8mm large flow high pressure compact solenoid valve

The valve can hold 150 bar high pressure, and orifice is 8mm, big flow.



Feature:


Very compact structure.


Seals: Viton


Pressure: Max 150 bar


Orifice: 8mm


Material: brass or stainless steel


Fluid: air, water, diesel, oil


Thread size: 1/4, 3/8, 1/2


Please visit XHnotion website for more information.

Comments

Post a Comment

Popular posts from this blog

The difference between pneumatic meter out and meter in throttle valve

Image
Throttle valve is called speed controller or flow control valve. They are usually positioned near to air cylinder to control the speed of air cylinder. Feature as below 1. Mainly installed in the air actuator. 2. Working Pressure: 0-150 Psi. 3. Working Temperature: 32 -140°F / 0-60℃ Meter Out throttle valve The flow rate of air entering from the thread side can be controlled, whereas air entering from joint side comes out from the thread side at the same flow rate (not controlled). Meter in throttle valve The flow rate of air entering from the joint side can be controlled, whereas air entering from thread side come out from joint side at the same speed (not controlled). Flat type flow control valve The way to control of flow or control flow upon piping in accordance with the signal on the body. Air flows from each side of valve.
Read more
Image
Safety Push Button Coupler It used for connect and disconnect and its max inlet pressure can reach 225 Psi. It comply with standards ISO 4414 and eliminates all leaks when coupled or uncoupled. SAFETY 1 - Press button once: [...] Email This BlogThis! Share to Twitter Share to Facebook Share to Pinterest Labels:   flow control valve ,  pneumatic fittings ,  pneumaticthrottlevalve ,  speed controller
Read more

The issues you might concern about stainless steel SS316L push in fittings

Image
Stainless steel (SS316L)push in fittings are made to be non corrosive and are highly resistant to aggressive environments, as well as corrosive fluids. These push in fittings ensure easy and fast connection, and removal of a tube easily. 1– It is very difficult to machine SS316L, can you promise the quality consistent? Answer: we manufacture stainless steel push in fittings strictly as ISO9001:2008 system. With the help of automatic CNC lines and Japan engineer, we can control the tolerances of critical dimensions. Meanwhile, we have digital screen to inspect the dimensions. After install fittings, we will test all the fitting one by one to make sure all is OK. 2 – We use the fittings in corrision fluid, can you promise 100% no leakage, how to promise? Answer: Seal material comes from Japan. We use V-shape FKM seals instead of O-ring, which perfectly fit the tubes inserted and avoid any leaking when you bend the tubes. Two O-ring design makes our swivel s...
Read more